離合器由動盤總成、離合器壓蓋及蓋總成、分離軸承、飛輪構成，一般車輛的離合器的使用壽命為6萬左右。攪拌一體機大多是手動擋的，手動擋的車輛離合器使用的是多的，攪拌一體機的離合器壽命短受幾個方面的影響：

The clutch is composed of a moving plate assembly, a clutch gland and cover assembly, a release bearing, and a flywheel. The service life of the clutch in general vehicles is about 60000 km. Most agitators are in manual gear, and the clutch of vehicles with manual gear is frequently used. The short life of the clutch of the agitator is affected by several aspects:

1.長時間踩住離合器，長時間踩著離合器不放，那么離合器一直處于工作狀態，這樣長時間的運轉非常容易造成離合器過熱，磨損過度的。

1. If you step on the clutch for a long time and don't let it go for a long time, the clutch will always be in working condition. It is very easy to cause overheating and excessive wear of the clutch after such a long time of operation.

2.長時間半聯動，這個指的是在車輛的行駛過程中，一直踩著離合，踩一半，放一半，這就屬于半聯動，也叫半離合，這樣會導致分離軸承壽命嚴重縮短的，剎車片的壽命也會縮短的，終也就縮短了離合器的壽命。

2. Long time semi linkage refers to stepping on the clutch, stepping on half, and releasing half during the driving process of the vehicle. This belongs to semi linkage, also known as semi clutch, which will lead to a serious shortening of the life of the release bearing, the life of the brake pad, and eventually the life of the clutch.

3.起步油門過大，對于手動擋，有些人在起步的時候，喜歡猛踩油門（離合器一端是連著發動機，另一端是連著變速箱和車輪），油門過大，發動機轉速一下就上來，離合器剛剛結合的時候兩端轉速相差就很大，一頭發動機已經轉的很快，那邊才慢慢接上去速度慢。這樣擰一下對離合器會產生額外的消耗，油門超大，要么離合器打滑，要么就是輪胎打滑，對車都是不好的。長時間這么開車會出問題，檔位高，速度低，從地面及變速箱傳來的阻力矩，就會特別的大。

3. The starting accelerator is too large. For the manual gear, some people like to step on the accelerator when starting (one end of the clutch is connected to the engine, and the other end is connected to the gearbox and wheels). The accelerator is too large, and the engine speed comes up as soon as the accelerator is too large. When the clutch is just combined, the speed difference between the two ends is large. One engine is already rotating very fast, and the other is slowly connected. This kind of twisting will cause additional consumption to the clutch. The accelerator is too large, either the clutch slips or the tire slips, which is bad for the car. If you drive like this for a long time, you will have problems. When the gear is high and the speed is low, the resistance torque from the ground and the gearbox will be particularly large.

4.檔位越高，阻力矩就越大，阻力矩和變速箱的傳動是成反比的，變速箱的檔位越高，傳動比越小，阻力矩就越大，那連接發動機變速箱的離合器，承受的負荷也就越大，就會加速離合器片的磨損。

4. The higher the gear is, the greater the resistance torque. The resistance torque is inversely proportional to the transmission of the gearbox. The higher the gear is, the smaller the transmission ratio is, the greater the resistance torque is. The greater the load the clutch connected to the engine gearbox will bear, which will accelerate the wear of the clutch plate.

針對攪拌一體機離合器使用壽命短原因的問題分析，我們從四個方面來講解了，希望能夠給您幫助，更多相關內容就來我們網站http://m.cqsgy.com咨詢吧！

Based on the analysis of the reasons for the short service life of the clutch of the agitator, we explained it from four aspects and hope to help you. More relevant content will come to our website http://m.cqsgy.com Consult!